Hammer mill daily production steps

Hammer mills will always encounter some unavoidable problems in daily production plants, mainly due to the lack of attention caused by operations. If long-term fixed grinding operations, should be fixed on the cement foundation; if the machine is a mobile business, the unit should be installed in the base made of angle steel to ensure that the power equipment (diesel engine or electric motor) and pulley groove grinding machine rotate in the same plane.
First of all, after the installation of fasteners, the ministry's timber factory inspections tightened. It is appropriate to check the tension of the belt at the same time.
Secondly, turn the rotor by hand before starting the equipment, check the teeth claw hammer, the rotor is flexible, the work is reliable, whether the shell collision phenomenon, whether it is the rotation of the arrow rotor and the same machine, the power direction direction hammer mill, lubrication Good sex.
Again, it should not replace the pulleys, the speed is too high to prevent the explosion of the crushing chamber, or the efficiency of the device is too low.
Finally, after the start of grinding, it should be idling for 2 to 3 minutes without any abnormalities. It should be fed after work.
Work should always pay attention to the operation of the lumber mill, feed should be uniform and prevent crowded and hot cars, not a long-term overload work. If there is vibration, noise, bearing and body temperature, spraying materials, etc., should immediately stop the inspection, troubleshooting, and then continue to work outside the phenomenon.
The material of the lumber mill is based on a hammer crushing machine. It is divided into a tooth crusher, a hammer crusher, an ultrafine crusher, a turbine, and a crusher.
1 The speed of a wood gear grinding machine operated by a stationary ring grinding gear with a relatively high speed spinning disk.
2 Hammer mill: The relative movement of high-speed rotating parts and fixed wooden rings crushed mechanical hammering activities. Hammer crusher and item activity Hammer plate parts are hammer mill and hammer hammer pieces to prevent partial grinding
3-Knife Grinding Machine: High-speed rotating gears and a relative motion of a stationary ring of wood machine blades, crush.
The use of hammer mills in the schedule if used with the above points can greatly reduce equipment problems and increase the life of the equipment. After each stop, necessary maintenance measures must be taken.